My 1997 Probe GTS

View Duration: 0:19

JDM motor swap with new gaskets and timing belt new distributor NGK plug wires and plugs VIS carbon hood eibach drop with tokiko struts hks muffler, no cat, pacesetter headers clutchmaster stage II clutch fidanza lightweight flywheel trans replaced poly bushings rear strut brace...

Mg Zs Redline.

View Duration: 0:35

me taking my zs to the redline.. BEFORE EVERONE STARTS SAYING ABOUT MY HEAD GASKET! its an aftermarket duel layer skimmed hg so it wont blow!

My lil 1993 Honda Prelude :)

View Duration: 0:35

Just me taking my 'Lude for a spin. This also was the day a valve cover gasket blew and I had to leave it at a friend's house (the guy holding the camera) for two days. Before you go calling it a rice-mobile, let me tell you, everything in this car is stock, inside and out, save for the radio...and ...

Rodney Mullen??? (on a miniboard) lol!

View Duration: 0:17

just a joke, dont pop a gasket because it not really rodney mullen

EBN 16 Plate Setup and Cold Start Tests

View Duration: 6:31

EBN Dry Cell with 16 Plates in +NNNN-NNNN+NNNN- configuration, 60mil rubber gaskets.

lower hole sealed

View Duration: 2:54

1/32 gasket +nnnn- x 6. Details at :http://www.ionizationx.com/index.php/topic,818.0.html

Burned Head Gasket

View Duration: 2:45

John shows a badly burned head gasket.

hho dry cell #014

View Duration: 6:13

this is a video showing my gaskets check it out

kubota diesel engine d950 starting up. tractor generator etc

View Duration: 1:43

a kubota 3 cylinder diesel engine. d950. with rebuilt head, new gaskets etc. just put a nissan radiator and electric fan on it. welded up the exhaust. built a switch box etc. glowplugs need changing as it takes 30-40 seconds of preheat to get going. temperature in the workshop was -1c so at least ...

Cleanin the garage and decided to ride the cr for a minute.

View Duration: 0:59

CR80RB Brand new fully rebuilt motor and all new gaskets. A few mods.